Impact of Power Factor on the Advancement of Equipment and Technology
Keywords:
Capacitor Banks, Oscilloscope, PIC Microcontroller, Power Factor, Pulse Width Modulation, Real Power, Reactive PowerAbstract
Power electronics equipment and high-voltage systems have become increasingly common, introducing additional harmonics into the grid. Harmonic contamination must be reduced, and transmission performance must be improved, which necessitates power factor adjustment. A number of methods have been proposed for power factor adjustment. The technique of utilizing a Programmable Interface Circuit chip to build the power factor corrector of a 3-phase power system was described and planned in this article. Sensors and a programmable interface circuit detect and measure the load's power factor value. The information is moved to an algorithm, which subsequently triggers capacitors based on the algorithm'sperformance. The capacitor also turns on the lag and lead power factors, which are shown on an oscilloscope LCD panel. This will assist to compensate for voltage regulation and contributes to a power factor that is closer to unity, thus enhancing the performance of the power system.
Downloads
References
.Aliyu AK, Bukar AL, Ringim JG, Musa A. An Approach to Energy Saving and Cost of Energy Reduction Using an Improved Efficient Technology. Open J Energy Effic. 2015;
.Onwude DI, Abdulstter R, Gomes C, Hashim N. Mechanisation of large-scale agricultural fields in developing countries - a review. Journal of the science of food and agriculture. 2016.
.Reed GF, Grainger BM, Sparacino AR, Taylor EJ, Korytowski MJ, Mao Z. Medium Voltage DC Technology Developments , Applications , and Trends. Cigre. 2012;
.Ketchman KJ, Parrish K, Khanna V, Bilec MM. Synergizing disparate component-level energy resources into a single whole building tool to support energy conservation action in small commercial buildings. Energy
Build. 2018;
.Crepaldi J, Amoroso MM, Junior OHA. Analysis of the topologies of power filters applied in distributed generation units-Review. IEEE Lat Am Trans. 2018;
.Ananthanarayanan S, Amudha A, Balachander K, Kavitha D. Design and analysis of power quality improvement in distribution side using PCC technique with fuzzy logic control. J Adv Res Dyn Control Syst. 2018;
.Nintanavongsa P, Yaemvachi W, Pitimon I. A self sustaining unmanned aerial vehicle routing protocol for smart farming. In: 2016 International Symposium on Intelligent Signal Processing and Communication Systems, ISPACS 2016. 2017.
.Greer JA. Design challenges for matrix assisted pulsed laser evaporation and infrared resonant laser evaporation equipment. Appl Phys A Mater Sci Process. 2011;
.Gakhar P, Manglani T, Doda DK. Advancement & Role of DG Technology in Distribution System. Int J Recent Res Rev. 2013;(June):22–31.
.Basso T, Chakraborty S, Hoke A, Coddington M. IEEE 1547 Standards advancing grid modernization. 2015 IEEE 42nd Photovolt Spec Conf PVSC 2015. 2015;
.Singh B, Singh S, Chandra A, Al-Haddad K. Comprehensive study of single-phase AC-DC power factor corrected converters with high-frequency isolation. IEEE Trans Ind Informatics. 2011;7(4):540–56.
